Why Fiber Cement Rewards a Careful Crew
Homeowners across Shiremanstown, PA choose fiber cement because it laughs at things that wreck other siding: fire, hail, insects, and rot. Behind that toughness is a simple condition. The boards must be installed correctly. A cut edge left bare will draw in moisture. A plank set too close to the ground will stay wet. A nail placed too near the edge will crack a stiff board. Complete Roofing treats these details as the job itself, not as fine print, so your siding delivers what the manufacturer promises.
How Installations Go Wrong
Almost every early failure comes from skipped basics. Unprimed edges swell. Missing gaps wick water upward. Wrong fasteners split boards. None of that is obvious when the crew drives away. It appears slowly through peeling paint, softened edges, and stains along the base of the wall, and by then the sheathing behind may be wet as well. Fixing a poor installation usually costs more than doing it correctly originally, which is why we do not rush the details.
Our Installation Sequence
Start With the Wall
Before opening any bundles, we confirm sheathing is solid, the weather barrier is continuous, and flashing at openings, roof lines, and low points is correct.
Mark Clearances
We measure and mark every gap the manufacturer requires, from grade to roof lines to trim, so each one is set intentionally.
Prime as We Cut
Primer goes on every freshly cut edge before the board is installed. No exceptions, no batching it for later.
Nail It Right
Fasteners follow the published spec for the product: type, length, spacing, and distance from edges. That keeps boards intact and protects your warranty.
Finish the Joints
Seams, trim, and penetrations are sealed using paintable products intended for fiber cement, never general-purpose caulk that will not hold paint.
How We Stand Apart
Primer on every cut: This single step prevents a large share of early failures, and our crews never skip it.
Gaps verified before hanging: Required spacing is measured against the manufacturer's numbers rather than eyeballed.
Nailing to spec: We use the correct fasteners at the correct spacing for your particular board.
Right sealants only: Products recommended for fiber cement keep paint bonded and joints watertight.
Trained installers: Crew members have completed fiber cement training from manufacturers, which supports skilled, informed installation.
Frequently Asked
It costs more per square foot for material and installation, owing to its weight and extra steps like priming. Its fire resistance, impact toughness, and long service life give many Shiremanstown, PA households a strong reason to pay the difference.
Yes. Paint seals the surface against moisture. Primed boards still need a finish coat, and factory-finished versions already carry one, often with separate coating coverage.
Boards weigh roughly two to three times what vinyl does per square foot, so they demand more careful handling and a skilled crew.
It could. Fiber cement is stiff and has little give, so if we notice movement or settling at your home we raise it and address it before we install.
Well. The material does not ignite, and building codes classify it as fire-resistant, which makes it a favorite in areas facing wildfire risk.
Usually somewhat longer than vinyl, due to board weight, priming of cuts, and tighter fastening rules. We give you a schedule up front.
Siding Services to Compare
Curious About Fiber Cement for Your Shiremanstown, PA Home?
Contact Complete Roofing to learn what a fiber cement installation involves for your house.